How to Check axle shaft

How to Check axle shaft 

Examination axle shaft is divided into 3 parts;

A. demolition

Remove the universal joints and differential dair middle of the frame buffer pads then remove the propeller shaft
Before removing the propeller shaft from the flange connecting members do not forget to mark the installation.
Enter the special equipment into the back end of the transmission to prevent oil leakage.
Prepare the propeller shaft above the work bench
Put a mounting flange yoke and propeller shaft.
Remove the ring and open the folder bearing spider / rear needle.
Open and remove the snap ring on the needle bearing / spider front.
Press one end of the needle bearing with a vise and a socket size of 14 mm and 21 mm so that the other side of batnalan the needle goes into the socket size 21 cm
At the propeller shaft to the bearing needle bearing is pulled out and the guard should not be falling.

B. examination

Wash disassembled parts and check for worn or corroded damaged.
Check out the possibilities which are numbered worn, damaged and deformed
Yoke connection circuitry sheath check the part that may have worn out, damaged and deformed.
Check the flange yoke universal joints worn and damaged possibilities.

C. assembly

Install the propeller shaft components corresponding serial numbers.
pairs on sipder on Yoke by using special equipment or tools and a wide presses which first mounted on bearings on one of the spiders in the same way.
After dipsang, subtlety examiner detour round the sheath or flange yoke to the left and to the right.
Install the shaft with fittings after installation of signs made ​​time to remove matched.
When installing propeller shaft 3 connection, first adjust a position in the middle of the vehicle bearing no load.
Suitable bearing center line should be perpendicular to the central axis of the center line.
Set the completed installation of the connection Univesal, sheath yoke that goes into the transmission should be given lubricating oil
Pump up the fastening bolts according to specifications.